Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I installed a 3550 switch and am routing 3 subnets between vlans with ip. The problem came when I tried logining in with an ipx client - can't gain access. We have a couple of old Windows clients using ipx and no ip to access a Windows server using i...
My company has obtained additional public ip's but they are not contiguous to our original ip's. Is there are way to configure ethernet0 to use more than a single public ip? If so how? I am using a pix 515 with version 5.2(6). Thanks.
I have configured a Pix 515 for VPN access with authentication though Microsoft IAS on a Win2K server located on the "inside" of the Pix. I can connect, receive an IP from the Pix, and am authenticated on the Win2K IAS/domain controller server and ca...
I didn't turn on portfast, and I'll have to check to see if the servers and clients are in the same vlan - I don't believe that they are. Thanks for the info. I'll just push these clients to IP if they are in different vlans.
The most helpful doc that I found is at www.cisco.com/warp/public/110/pptppix.html. I did have to add the vpdn group 1 client authentication dns XXX.XXX.XXX.XXX command, as mentioned above, that was not in this doc. Good Luck.
I solved part of the problem by adding a DNS entry into the Pix config. This allows me to "net view \\servername" but I am still having trouble graphically browsing the network on the Win2K client. I found earlier postings involving WINS, but I would...
