Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please can someone just over look my network configurations for RSPAN.In order to monitor internet traffic entering our network environment through our front-end ISS firewalls we’ll need to setup our IDS server. The following work listed below will ...
I have six switches, some 5500, 4006, 6513. All of these switches connect into my one 6513 switch with trunk links. The root bridge is one of the switches trunk into the core 6513 switch. Correct me if I'm wrong, don't all traffic go through the r...
My 5500 switch has been up for over 500 days without being rebooted. The switch is very slow and the message below keeps popping up in the log.%SYS-4-P2_WARN: 1/Astro(4/3) - timeout occurred%SYS-4-P2_WARN: 1/Astro(4/3) - timeout occurred%SYS-4-P2_WA...
I have a clinet that is trying to ftp to my ftp server...because he was unable to change his route from the test server to the production server I figured I would nat his source address to the new ftp server (source) 170.146.x.x to my ftp server 206....
Hi,1) On switch T14 I don't have any users but VLAN 508 is configured on that switch. I have a firewall connected to T14. I need to monitor the whole VLAN 508.2) On switch T15 I don't have any users but VLAN 508 is configured on that switch. I have a...
Hey,I have two switches, T014 & T015 there connected via trunk links, the Sensor is going to be connected to switch T015. The VLAN I need to monitor is VLAN 508, that's my internet VLAN. VLAN 508 is configured on both switches T014 & T015. VLAN 80...
Thanks, you have been very helpful. I've attached my final configuration (hopefully). I've removed the stuff you said to remove. You don't see the interface on T014 because I found out that I don't need to have that, but the other configuration is...
