Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a l3 switch (3850) to a ISP router which has built in redundancy (fibre and wifi external connecting) managed by the ISP.The l3 switch is in a stack of 2 and I want to add an additional link to the router for hardware redundancy.What config wi...
Hi, Looking to upgrade a standalone FMC and FP modules located at different sites. 1. I am unsure of which model of FMC I am running how can I tell?Also unsure of the software version the FMC will need to go to. When looking in the cisco software do...
Hi,
I do not have access to the router onsite but I do have switch access. The line has recently been upgraded from 200-800mbps how can i test from the core sw or access layer switches what speed they are getting?
Currently switches are connected via SW1 Gig 1/0/25 > SW Gig 1/0/6
When I connect the second fibre link the channel goes down. Does the config look OK, what else could be causing this?
SW1
GB34SW1039#show run int gi1/0/25Building configurati...
The 3850 is connected to the ISP router with the below config:interface GigabitEthernet1/0/16description QuickLink CPE WAN Routerswitchport access vlan 902ABC (Fibre)Gig 1/0/16 95 R Quickline vrrp1ABC (Fibre)Gig 1/0/16 95 R Quickline bridge0Device ID...
ThanksThe latest Firpower version is 6.3, but ASA 5512x does not support 6.3. So you can Upgrade upto 6.2.3.11 until now.Am I able to go straight to 6.2.3.11from 6.2.1?
Hi Paolo,
What release version of 3.1 are you running for that trace, as I get similar results to the others above, in that it stops working when client set to TLS1.1 so I wondered if a certain versions of 3.1 worked whilst others didn't.
I notic...
