Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am configuring CUCM using SIP for a brand new install. I have tried to generate a call using the Cisco 7945G. First I enabled auto-registration and enabled dhcp but no luck. Then I disabled auto-registration and configured the phone with an ...
Hello, I'm configuring ACE 4710's for the first time and I want to load balance my Nuance speech servers on port 554. Here's my configuration on ACE01:hostname ace471001interface gigabitEthernet 1/1 switchport access vlan 1000 no shutdowninterface ...
Right now, the phone is registered, all the services are running. I think connectivity is OK from the phone to the server but I'm not sure. Right now the phone is connected directly on the catalyst switch. From the switch I can ping the server. What ...
This should do it:probe rtsp probe01rserver host nss01 ip address 10.2.4.70 inserviceserverfarm host Nuance_Lab rserver nss01 554 inserviceclass-map type rtsp loadbalance match-all L7SLBCLASS 10 match rtsp url /synthesizerclass-map match-all V...
Hey Cesar,Thanks for your response, I made the changes. All that's left now to test it.Once again I appreciate your help:probe rtsp probe01rserver host nss01 ip address 10.2.4.70 inserviceserverfarm host Nuance_Lab rserver nss01 554 inservicecl...
Hi Cesar,I modified VIP so I think I'm good now: probe rtsp probe01rserver host nss01 ip address 10.2.4.70 inserviceserverfarm host Nuance_Lab rserver nss01 554 inserviceclass-map type rtsp loadbalance match-all L7SLBCLASS 10 match rtsp url /s...
