Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Gentlemen, Need your advise. Outline •- L2 switches with default GW 10.3 to FW VRRP•- Trunk each other with default VLAN 1 for all the ports except trunk port Gi0/2•- Physically connected to 10.56 SVR...
Hi,I have one ASA 5510 FW with AIP-SSM20 additional IPS module and security plus license. I noticed that this IPS module come with Virus/Worms/Trojans signature configuration . ( Pls.refer to attach pic ). I'd like to know how do I receive the servic...
Hi, Could you please help to advise? I have issue on my project . I have already setup the ASA 5510 and configured eth0 for outside ( security-level 0) , eth1 for DMZ (security-level 50 ) and eth3 for internal network ( security-level 100 ). I want t...
Hi,I am not very familar with security devices .But our project need to test the file sharing performance between the Redhat ENT Linux servers segregated by ASA 5510 FW as per attach. We would use rsh, ssh , ftp ,rcp protocols in order to transfer th...
Hi,I have one network deployment project and have setup the IPSec site to site VPN tunnel using the ASA 5510 FW.But according to our customer requirment, we need to prove that the tunnel shouldn't be able to sniff the data betwwen two sites. Is there...
Thanks Song Li, It's that what I want . Would like to know will there be any reboot to the IPS moudule after the package is applied. And any documentation about this package ? Or what is the steps that package need to upload to the device and applied...
Hi Mohamed, I have managed to configure all outbound direction ( INSIDE--> DMZ1& 2 , INSIDE --> OUTSIDE , DMZ1,2 ---> OUTSIDE. But still not able to access inbound direction ( OUT --> DMZ 1,2 , DMZ1,2 ---> INSIDE ). Kindly advise how to al...
