Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Currently my GUI Fabric Interconnect cannot be access due to failed firmware update. I'm still trying to find maintenance window for this error. Anyway I can give you the show running-config for that interface. !Command: show running-config inter...
Hi,There is some silimiar question before.Please look here..https://supportforums.cisco.com/thread/2185692https://supportforums.cisco.com/thread/2195410?tstart=60Thanks,Pieter
Hi Michael,yes. I'm using 5108 Chassis, and using two UCS-B200 M3. connected to UCS-FI6248 using 2 copper cable (10Gb).and the VNX5300 connected using 2 copper cable (10Gb) and 2 FC (8Gb) cable to FI6248.Hope thats helped.Thanks,Pieter
Hi,I'd like to confirm you, that passive assembly is supported. Haven't tried the actives one yet.I'm using UCS-B200 M3, and EMC VNX 5300.the EMC VNX5300 (Block Level) connected using 2 type of media. Copper (SFP-H10GB-CU5M= 5-m 10G SFP+ Twinax cable...
