Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're using 887VA's at branch offices and leveraging IOS ip dns server for split DNS with IPv4 clients.Is there a way to have DNS server listen on IPv6 also?So far I've been unable to locate any specific documentation on this feature, but there are s...
Our primary link was being saturated and a second ADSL HWIC was installed into the 1841 to host the DMVPN Hub on a dedicated ADSL circuit.Dialer0 is the default gateway for general internet traffic and the Dialer1 hosts the DMVPN Hub.The problem I'm ...
Hi,Our primary link was being saturated and a second ADSL HWIC was installed into the 1841 to host the DMVPN Hub on a dedicated ADSL circuit.Dialer0 is the default gateway for general internet traffic and the Dialer1 hosts the DMVPN Hub.The problem I...
Does Cisco IOS include a feature to proxy TCP/UDP connections?I have a legacy device on the LAN that we need to reach remotely, but frustratingly it doesn't support adding a gateway IP.RegardsRob
I'm hoping someone can shed some light on getting this to workWe've got a Cisco 877W (Test) & 1841(prod) with two PPPOE/Dialer interfaces to two different ISP (NAT overloaded). We've tried the examples on both platforms and with 12.4 and 15.1. We hav...
This thread reports 1921 works but not the 1841. I'm using the 887VA which is newer than the 1921.Where can one find which platforms are supported? https://community.cisco.com/t5/ipv6/does-quot-ip-dns-server-quot-on-a-cisco-router-listen-on-ipv6/m-p/...
There was another thread similar to this, that mentioned that it supported on some platforms? I don't believe anything special needs to be configured above the above commands. On some platforms it listen on both ipv4 and ipv6. Be good to know which p...
