Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have an application that needs to use multicast in a computer lab area. I have decided to only enable multicast on two switches and block it from the rest of the network using the port storm control command on the 2950 EI switches. I have b...
Hello,We are looking to setup private addressing down at one of remote sites, we also want to setup vlans for each building. The current router we have down there does not support VLAN trunking, it's fairly old. We are looking into buying a "router...
Hello we have a number of Aironet (Before Cisco) Wireless AP's, it's the model Aironet 4800 Series Turbo DS Model# AP4800-E, and I was wondering if they were WPA 2.0 compatible and if there were any upgrade kits to make them compatible if they are no...
I have been searching Cisco's website looking for information on available switch blades, but I haven't really been able to find the information I was looking for.I am looking for information on Cisco Switch Blades that have 10 Gigabit ports, I don't...
I was looking on Cisco's site and was having trouble finding a section on blade compatibility between 2 different switch models. We are thinking of going from a Cisco (WS-C4003-S1) to what Cisco recommends a Catalyst 4503 Switch. I was trying to fi...
I'm using the following script that was published earlier in this discussion and its working fine. I want to trim the output but not being a script guy, I can't find where it does this. I don't want the neighbor port to be written out (Gi0). Here i...
