Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just recently I have had a couple manual HA failovers between a pairs of HA WLCs fail due to the standby unit being in an apparently unhealthy state.Besides checking for "Peer State Standby Hot" and "Bulk Sync Status Complete" What are other Best Pra...
I want to give some users in my organization the ability to use mobile devices to VPN into our network, but I don't want just anyone to be able to do so. I'm not seeing a way I can specify that AnyConnect for Mobile can only be used with a particular...
When I do an NMAP scan against my ASA 5505 on it's internal interface's IP address, it appears to be listening on all TCP ports. If I do it from across a VPN tunnel, the ports show as open according to NMAP, if I do the scan from the local subnet th...
Due to PCIDSS requirements I need to have IKE aggressive mode disabled on all the devices that terminate VPN Tunnels. Unfortunately I have several PIX 501s out there that don't have the capability to disable IKE Aggressive mode. Would it work to cr...
I've done some looking and haven't been able to find an answer to this. Is there a way to direct a user to a specific SSL VPN profile based on the URL they enter to get to the SSL VPN page?
Do you have any suggestions for what sort of things to look for when running the above commands? Things that might indicate an an issue on the standby that needs to be addressed before performing the failover?
