Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question maybe someone can answer:Currently a PIX running 6.3(5) will work with Microsoft NLB running in unicast mode because it won't reject arp entries that are multicast ethernet with a unicast ip entry. All flavors of cisco routers I kn...
I am trying to set up a T1 controller to handle QSIG to the corporate PBX. The router and PBX are talking to each other, when I do a debug voice ccapi I can see the router picking up the dialed digits, but it is not passing them off to a voip dial p...
Actually, using frame-relay traffic shaping and a map class you can define the udp port range starting as low as 2000. But you won't have the same range of ports. ie 2000 + 16383 = ports 2000 to 18383. So you would have to make sure ALL of your equ...
Thanks-I've looked at buffers and controller stats and nothing jumps out at me. I'm trying to tie this is with some problems I've experienced on eigrp where I'm losing all my neighbor adjacencies. I agree, the interfaces are being over-run by a pro...
