Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We try to activate multicast here and it does not seems to work properly. There is our configuration : Core : 4506 with L3 routingDistribution : 3750 L2 onlyAccess: 2950 L2 onlyOn the 4506 we have those commands configured : ip multicast routin...
Jon, you are the king! It working pretty fine now that I have ip pim sparse-dense-mode activated on VLAN 1 on both Core Switch. I forgot this command on the VLAN1 interface. I set this command on all interfaces, but I had not thought the VLAN1. I und...
Hi Jon,yes, x.x.1.2 is the VLAN1 interface IP address on the CoreJ130 Switch. This switch is the HSRP Active and it's the same active switch for vlan12 and 48 (src/dst)I've removed the ACL on VLAN 1 for testing purpose and still not works. There is ...
Hi Jon,The Source is x.x.12.21The Receiver is x.x.48.210There is not ACL on VLAN12 and VLAN48. Only ACL to limit access to VLAN1I've paste the vlan intercace config only for VLAN12 and 48.here is the capture requested: From CoreJ130 x.x.1.2 COREJ130#...
Jon,From the PC on the VLAN12 I can ping the CoreJ130 (x.x.x.2) but I cannot from the PC on VLAN48 because there is an ACL that limit access to CoreSwitch. I made the test from my PC that have access to CoreSwitch. Do I have to create a loopback int...
