Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just converted a new site to VoIP. We utilize a centralized CUCM cluster running 7.1.5. Each site has its own MGCP or H.323 gateway with a PRI to the PSTN. We've utilized ATA's for fax connections at other locations with no issues; however faxi...
I'm looking at configuring QOS across a frame-relay WAN. We have a 1536 Port/768 PVC. My question is does the router base the bandwidth percentages on the port or pvc speed? Thanks in advance for your help.
So it was working for a while, but now has suddenly stopped according to the onsite personnel. Same issue, receiving faxes is ok but cannot send. Attached is the debug of a recent attempt. Any ideas?005292: Aug 12 18:25:48.160 UTC: //-1/55C1E04184B...
1-418-598-9972 is being dialed. I'm not onsite but I do believe they have a pots we can test with. I'll have them hook it up and try dialing the number.
Below is the config. The fax should be dialing out on the PRI. It is not defined in or using CUCM.card type t1 0 0!isdn switch-type primary-dms100!voice-card 0 dspfarm dsp services dspfarm!!!!!voice translation-rule 1 rule 1 /^\(4506864[4-5]..\)/ /...
I added your config, but it still not working. Below is the debug again, as well as the relevant configuration.002129: Aug 12 12:37:37.807 UTC: //-1/B222F7D18200/CCAPI/cc_api_display_ie_subfields: cc_api_call_setup_ind_common: cisco-username= ...
