Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Experts,
I hope all is well, i have a client that is very conscious about his building interiors and wants to conceal as much as possible the access points, although some of this access points are external access points with sector antennas, is the...
Experts,
is it possible to use a single vcsc connected with a vcse ver 8.11.4 to do both mra and to do b2b at the same time? If so what is the requirements?
Or you have to have one vcsc/vcse for mra and another vcsc/vcse for b2b ?
Hello experts,
Can Someone clarify as to whether Cisco vcs edge in MRA mode supports ca signed wild card certificates? And what is the best practices for the ssl certificates?
to install CA signed ssl certificates in the controller as well as the...
Hello Experts!
Can someone please clarify how does the Client traffic traverse the network when there is a local WLC without Flex connect.
Lets say I have the following easy topology
ISP Router
Firewall
Transport Switch
Core Switch ----------WL...
Rasika,
So It seems that I could have a global deployment with HA pairs of WLC's in different Parts of the world (datacenters) to control the AP's in different Sites with different bandwidth's and it this set up will work pretty well. Is there any ...
Rasika,
Thanks again, as a subject matter expert that you are, what would you recommend to an enterprise with several offices around the world with existing multiple controllers , and sometimes with controllers positioned locally at a each site dep...
Rasika,
This is exactly what I was looking for. So in your opinion why would an enterprise set or configure Local Mode AP on a WLC? Thanks a million again for your valuable time.
Rasika,
Thanks for the response. Then what you are saying is that ALL in/out traffic comming or going to the AP traverse the WLC. Instead of routing it via the Switch of where the AP is connected. Although I actually to clarify this I did test usin...
Scott,
Thanks for the clarification and how does the traffic traverse with flexconnect. Because I put a tap on the link between the WLC and the switch and I do see capwap traffice but i do not see client traffic. Does this mean that when the wlc is...
