Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have tried to upgrade the 340/4800 to work in conjunction with the 352 , however after accepting the code the 4800/340 after reboot hangs completely and will not reboot .
I installed a Cisco 3620 with dual E1 cards at a central site, but all the remote devices are ACC/Ericsson Congo ISDN routers. I have tried every combination of compression setting the Congo allows, but without success.Has anyone had any success with...
Nothing easier. Simply set up a static route to the same destination via the external device with a hop count of 15.When your normal route is unavailable it will automatically have a hop count of 16 and your ISDN link will become usable.
Asynch will only go to 1115200, but the signalling type is completely different btween X21 synch and Asynch. For Frame, X21 leased lines and megastreams you need an interface which supports Synchronous signalling as well as AsynchStandard WIC-1T for...
Your main interface serial0/0 is described as 512K burst rate, 256K comitted rate. The actual bandwidth 512 setting is purely for statistical analysis purposes, and not a measure of actual bandwidth. All that happens when you change this is that stat...
Yes, you can use a bridge, or a router acting as a bridge. I don't understand the Token Ring reference - bridging works on Ethernet Lans quite happily.All you need to do is make sure the WAN and LAN ports are in the same bridge-group.
