Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team,We used the following commands to check the throughput on our Cisco Asr 1001x router, and the outputs were as follows. However, their throughput different. When we use the show license command, throughput is shown as 10G, while when we use ...
We are using a port channel for our up streaming router (Cisco ASR1001x) and there is a problem after configuring the port channel of it. We used GigabitEthernet0 / 0/0 and GigabitEthernet0 / 0/1 to create that port channel. But there is no Rx traffi...
Dear Team, We used two HWIC cards with this 2951 router and we had some problems after stacking those HWIC cards. First, we configured the router and saved them, but after we restart the router and check the router, we can see those stack ports are i...
Dear team,We have a problem with the high processing issue of the router. This router also performs multicasting .So we need a quick fix for this problem. Please provide some solution or advice for this problem. We have attached a screenshots with th...
There is an issue with one of our router (Cisco 2851).Suddenly the router got down.After we checked the logs we found some log messages in observium and we could not clarify directly what are the mean of this logs yet.Here I attached some snap shots ...
Dear Team,I appreciate your quick answer. We also have another Cisco ASR 1001 x router and when we run the show license command, it shows throughput as 5G, but when we use the show version command, nothing is displayed.Could you please tell why that ...
The port channel did now work properly.When the traffic transferring process only one port is work(Gi0/0/0) but the other port(Gi0/0/1) did not get the traffic through it.Please find the following details of the show interfaces summary. Metro-ASR100...
Here I attached the log messages that we got before the reboot . If you can figure out what's causing this issue, please respond to us as soon as possible.
