Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a question in regards to configuration I'm planning to implement. I currently have 2 x 3750 running in a stack. I would like to add 1 x 870 router connected to both switches.It's important for me that 870 is always available (it will on...
Hi all,I have a problem with new SIP trunk. I configured SIP trunk but for some reason CUCME is taking registration username and it's trying to match called number with this username instead of maching phone number with invite messages. My debug (deb...
Hi,I'm running small CUCME network and directory lookup is working correctly for internal phonecalls (using service dnis dir-lookup) but when I open my directory and dial outside number this feature is not working. I can't do directory lookup on inco...
Hi all,I have a problem with my system. I have C2801 and 4 phones (2 SIP phones and 2 SCCP phones). I'm trying to configure SIP trunk and SIP phones to work on 1 system so router can work as SIP client (for trunk) and SIP server (for phones) but I ca...
Hi all,I have a small problem with directory on my phone system and I hope Cisco Community might be the way to go. I use CUCME 8.6.My problem:I added few entries to my directory. When I'm dialing out I need to add 9 to go out which means my number in...
Hi leolaohoo,I already done this part. Do you have any feedback in regards to connecting router to both switches in the same time and spanning tree?Regards,Pawel
Hi Christian,Can you check on the phone if new firmware has been applied? (Under settings check device status) and can you post TFTP debug (debug tftp events)?Regards,Pawel
