Hello again. I'm posting an update regarding this:   - as Universal WGB it worked fine for a ethernet connected laptop - I tried to connect (as a lab at least, because it would be an "expensive solution") another AP configured as a root with another SSID in guest-mode and I get IP addresses for BVI and ethernet port (if configured on each interface) from the Linksys router, but I can´t get an address for the wireless clients when they connect to this "other" SSID (the one from the "root AP").   I'm missing DHCP configuration or there should be none for a root AP to get DHCP from the ethernet port?   Thanks again!!! Great week for everybody. ... View more

Thank you very much for your reply, Ric, I'll be checking the page you posted later, but one question regarding a test I didn't perform yet and just came to my mind: since the BVI1 gets an IP address and also the default gateway is set of course for the same reason, shouldn't it work as a bridge to another radio sub interface? Using a different ssid? Everything in bridge group 1?     Regarding the dot11 association, should it get an IP address or it should remain with 0.0.0.0 in this case? (Or in the case of working only with the ethernet connected device, wich I didn't make it work yet, but I think I made a mistake with the MAC address for the client, so... today I'll try that again).   Thank you very much again!!! Best regards  ... View more

Hello again, Patoberli   Here is an update: I couldn't connect as WGB, but I could as universal WGB and specifying the MAC for the client.   This way the AP associates with the Linksys router and BVI1 gets an IP address from DHCP, but in the dot11 associations you can see the MAC of the router and the IP is shown as 0.0.0.0   I couldn't get the ethernet connected device to work either, but the radio connection remains...   I think I'm nearly there, but something I'm missing... any other great ideas? :-D    Thank you very much again for your help Best regards  ... View more

Thanks again, I'll let you know how it goes. Best regards ... View more

Thank you very much, Pato. As this document describes, I should configure "my" AP as WGB and connect to the root (Linksys router) without specifying a parent or anything? Only the SSID to connect to and the station-role...?   Other doubt regarding this is the connection of other ethernet devices... should be any other definition regarding the purpose of the ethernet port? Could this connected devices be wireless with more configuration? (maybe a dot11 subinterface...?).   Once more, thank you very much for your time and patience. ... View more

Thank you very much, Flavio, I'll keep trying a little more and I'll post if I find a way to do it (or not... meaning: me quiting). Best regards ... View more

Thank you for your answer, Flavio. There is no other way to broadcast a SSID and use as gateway another one? Maybe as a Bridge...?   I understand of course that Aironet Extensions or any propietary protocols will not work with other brands, but connecting and/or broadcasting an SSID with a WPA2 pre shared key... I don´t know, I've been trying and of course I couldn´t connect, but I assume it was ignorance of my part regarding wireless and APs in general... :-\ It's difficult to believe that there is no chance to use general standards only :-(   Thanks again very much. Best regards, and have a great week. ... View more