Hi Mike. Which IOS version are you running? Also, were any IP addresses configured on any interfaces at the time you enabled SNMP? Answers to these questions will help in replying to your question. Cheers.
What kinds of traffic are traversing this link? What encapsulation are they using? How are you determining that "the circuit does not seem to support the throughput they should be getting"? (Note: features enabled, CPU load, packet load, fragmenta...
You should use dialer string logic, instead of dialer map logic on the remote site. Dialer Profiles (discussed in my previous post) and Legacy DDR both support the use of dialer string command. If the call to the first dialer string is busy, the s...
Dialer Profiles can solve this problem. Given that the main site's BRI's have been provisioned as a hunt group by the telco, the remote sites' calls could potentially land on either of main site's BRIs, which presents you with this problem. Dialer ...
