Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've used 3750's with stack cables in the back for our LAN switches but our budget got reduced and we're looking for alternatives. I'm looking at 3560G as it's significantly less expensive than the 3750 series. When I asked my account rep if they're...
I have 2 3750 switches:1. 3750G-48PS2. 3750E-48PDHow do I determine which IOS should be installed so that I can complete the stack? Right now they're stacked but I'm getting a version mismatch. The 3750E is the master and has the following IOS: c...
I have a Cisco 3750G Series and I tried to upgrade to a new IOS:c3750e-ipbasek9-mz.122-58.SE1I've clearly made a mistake because now upon reload I get the following error and then the switch reloads. hardware not supported by firmware. Try load...
Good morning I'm tasked with discovering the POE usage of our LAN switches to ensure the proper switches are in the best place in terms of our IP phone setup. Is there a command or a set of commands that I can use?I've used SH POWER INLINE which give...
I added an NTP SERVER to the configuration of a 3750 which looks like it brought down the IP HTTP Server on the switch. After the NTP was added, my monitoring software (What's Up Gold) shows IP HTTP Server as down, and in my CNA (Cisco Network Assist...
Thanks Reza, but I'm concerned about this:"Before you load an image make sure to read the release noted for caveats fixes, features and bugs for it.We have seen several posts here dealing with 12.2(58) issues. So, to be safe, I would load an earlier ...
