Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to do policy based routing based on the incoming IP address. All the addresses are coming in through a VPN concentrator and will be directed to one IP address on the concentrators policy, the concentrator will then pass the traffic to a switch...
I have a VPN concentrator that I have multiple Lan-to-Lan tunnels on. I want to be able to re-direct the traffic to different servers based on the source IP address comming through the tunnel. Each connection already talks to a specific IP address on...
HelloPardon any lack of knowledge we are new to IDS, we have a CW Server, a 4210, and a 4235. We can get our sensors upgraded to current versions but we cant get the CW server updated past s47.As we understand it both the sensor and the CW server ha...
I have run into a problem that has me puzzled and wondered if anyone has seen this before.I can not do a tracert from any desktop inside my network no matter what the destination. I can log onto a switch and do a traceroute from there or I can log in...
HI Satya,Thanks for the response. Let me give you a more specific example of what I am trying to do. Lets say I have an incomming address of 172.16.72.21 and it is trying to access port 14635 on 10.10.10.100, but as this packet comes in I really need...
Note the information in the following article, It shows PBR being allowed on 3750 switches.http://www.cisco.com/en/US/customer/products/hw/switches/ps5532/products_configuration_guide_chapter09186a00801ee86e.html
We updated to 60913, found it odd that it had no details under the about this server area.post that patch we tried to update the signatures again via monitoring center, security monitor, admin , config, update. Then we add a dummy sensor via managem...
