andrew-mccabe
Level 1
Level 1
Member since ‎08-10-2008
‎08-18-2017

User Statistics

  • 39 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 10 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

When this started, I cannot be sure, but it has been working for sometime now and cannot understand where the problem is.There is one guest interface, one guest WLAN. The WLAN is set with a DHCP override address of the guest interface. But it no long...
I wonder if anyone has seen this before...I have a pair of 5505's in transparent mode and connected them to C2960S. The inside interface (which is VLAN5 on the switchport) keeps dropping, going in to error state. There is no log reference in the swit...
Cisco are regularly quoted as saying Aironet 1240/1250 series AP's are designed for challenging environments. What I want to know is what are the 1240/1250 series AP's IP ratings. Anyone?
I am using 6.0.181.0I want to understand what the thresholds are for WCS alarm severity levels. For example, I received an alarm indicating it was low on disk space "did not meet the requirements", but I want to know whether I can adjust these thresh...
Recently two H-REAP AP's I have installed at a remote site are constantly reassociating with the controller (every 30 seconds). The WAN link is fine and there has been no changes since installation. The trap message is "AP 'UKGLRF01', MAC: 00:21:d8:7...
Community Statistics
Member Since ‎08-10-2008 11:45 PM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 39
Total Helpful Votes Received 10
Helpful Votes From