Hello all, I am trying to figure out a way to get Firesight to create/send a monthly report that shows the number of trojans, botnets, intrusions atempts and malware are identified/blocked. Any help documents on this area? Any help is appreciated...
I need some guidance to find a good book or material to use in setting up a new IDSM-2. Would prefer it to be fairly easy to understand to a new user setting it up. I could open a TAC case because I do have Smartnet but I would rather try and learn...
I am looking to break up a flat network into separate subnets according to function. How many secondary IP addresses can be used on a routers ethernet interface?
Like I said I am looking for the same thing. I talked to Cisco and the 2811 with a NM-16ESW is probably what you are looking for. Retail on the router is $2400 and the NM should be around $1700 list. You can get them for less through Optimous Solu...
I have been looking at the same area lately. Allot depends on what you are willing to spend. I have looked and most like the 2600 series only come with two on board. You can then buy a NM-2FE2W and increase the count to 4 interfaces. If you need ...
Thats a great Idea. I did not even think of going the sub interface route. That may be the answer I was seeking. I knew about them and have used them when dealing with Frame relay but did not think to use them for this.-Joe
I am looking to buy 2 2800 series routers with gigabit interfaces and use the secondary interface feature. Unfortunately the person before me purchased 3Com gig switches that do not have the ability for etherchannel that I have found. I also want t...