Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Please can someone help with a failover issue that I ahve and Ijust cant get my head round it..I have two sites connected via 10G LES link and I have a Cisco ASA 5520 at each site. One of the Sites is the DC and the other is our DR site.I have...
Hi AllI saw this post and have a similar issue; my Cisco anyconnect VPN clients are able to access all of my internal networks accept to another site which has a IPSEC VPN site-to-site. The Cisco ASA forwards the packets destined to this remote s...
Hi,This thread is interesting (although its an old one), as i have a similar requirement. i will have remote sites that will use IPSEC site-2-site VPN back to the HQ firewall in the event of the WAN failing. At the HQ I have two firewalls connected t...
Hi AllI have a situation and need some advice if possible.I have a 6500 series with SUP720-3B and I need to to do some kind of PBR so that my outbound traffic to the internet goes via ISP1 and my inbound VPN traffic goes via ISP2. The setup is as fol...
I am implementing QoS on our MPLS network. Our environment exists of a mix of Cisco 3750 and 3560 switches. The IPT system is Avaya CM with Avaya phones.The WAN network is a MPLS network.Ports are configured for access and voice vlan (no trunking),...
I entered the default values and failed back to the primary firewall; it lasted for a few minutes and then failed over to the secondary firewall again..
Hi Varun,I have enabled logging at debugging level, but nothing is in the logs after I have re-created the issue. I have failed over nearly 10 times so far but aprt from the show failover history command nothing else is informative about what is goi...
Hi,More information regarding the failover. i thought it may have been one of the DMZ interfaces failing that may have been causing the failure so I disabled them and that has made no difference..The logs show no information when the primary fails o...
Hi Varun,Attached are the failover configs from both units as well as the failover statistics. Thank youSecondary Firewall (currently Active)BEDFORDASA# sh run failfailoverfailover lan unit secondaryfailover lan interface FAILOVER GigabitEthernet0/3f...
