About Ahmet Mustafa Mungan

Ahmet Mustafa Mungan · 04-30-2019

Hi, If I know the EPG name, I could find the policy tag of that EPG via "show epg" command on APIC.However if I know only the policy tag, how could I find the EPG of that policy tag via CLI. I couldn't find this information anywhere. Kind Regards,Ahm...

Ahmet Mustafa Mungan · 09-05-2017

Hi all, As far as I know, when a router receives an IPsec phase 1 negotiation packet, it only checks if it has a configured ISAKMP key associated with the source IP of the packet. However, when a router receives a IPsec phase 2 negotiation packet, it...

Ahmet Mustafa Mungan · 07-27-2017

Hi, I have a lab environment with 2 routers connected via IPsec tunnel. I used crypto map for IPsec configuration. When I used ping command and the traffic matched with the ACL, packets above 1438 were fragmented. However, both Layer 2 MTU and IP MTU...

Ahmet Mustafa Mungan · 01-21-2017

Hello everyone, I have read lots of different documents about silent mode in PAgP. However I still did net get the purpose of it. This is from Cisco: Use the silent mode when the switch is connected to a device that is not PAgP-capable and seldom, i...

Ahmet Mustafa Mungan · 11-04-2016

Hi everyone, As far as I know, for traditional STP, switches finish all the negotiation process of STP in listening state. On learning state, they just learn MAC addresses. In those conditions, I think there would be not much impact if learning stat...

Ahmet Mustafa Mungan · 04-16-2020

Sergiu, Thank you for all the information. It seems that we have to downgrade and upgrade the switch then. We had opened a TAC case in parallel. Tac engineer said that there are two options for upgrading BIOS. Via Root Access (that only TAC engineers...

Ahmet Mustafa Mungan · 04-16-2020

Sergiu, Firstly, thank you for your answer. I know that I can do it with downgrade-upgrade. However, it means that everytime when we add a linecard to spine, we have to do downgrade-upgrade process for spine switch. Is there any easier way to do the ...

Ahmet Mustafa Mungan · 04-16-2020

Hi, In document, he says that "/bin/check-fpga.sh FpGaDoWnGrAdE" command upgrades both FPGAs and BIOS. However, when I use the command in 14.2.2f version, it only upgrades FPGAs. Is there another command to upgrade BIOS? Kind Regards.

Ahmet Mustafa Mungan · 05-02-2019

Hi Remi, Moquery command was a perfect advice. Thank you so much for your support. Kind Regards.

Ahmet Mustafa Mungan · 04-18-2019

Hi, We also have exactly same problem. What is the difference between NX-OS and ACI mode for 100 mbit connection. Kind Regards.

Member Since	‎01-11-2013 01:45 AM
Date Last Visited	‎04-22-2020 12:29 AM
Posts	23
Total Helpful Votes Received	1

User Statistics

User Activity

ACI CLI Command to Display EPG of a Policy Tag

DMVPN over IPsec Question

What is "plaintext MTU"

PAgP silent mode

Why STP Learning State Exist?

Re: Upgrade ACI Leaf/Spine Switch without APIC

Re: Upgrade ACI Leaf/Spine Switch without APIC

Re: Upgrade ACI Leaf/Spine Switch without APIC

Re: ACI CLI Command to Display EPG of a Policy Tag

Re: Nexus 93180YC-EX 100Mb on ACI vs. NX-OS