About jaiello2000

jaiello2000 · 08-20-2002

I have connected two 2600 routers with NM-HDV using T1 E&M signaling. I am trying to test SIP into one router, TDM voice to the other router and SIP onto the next ednpoint.The problem is that I can see the digits on the "far end" router, but the cal...

jaiello2000 · 07-12-2002

I am trying to figure out how to make/ensure there is ANI/Caller ID on outgoing POTS dial-peers. This has been a frustrating challenge… I have T1 E&M connections to both a voicemail (Octel) and PBX using both a 3660 and 2651 gateway. I simply want to...

jaiello2000 · 02-13-2002

Has anyone done this? Can you offer any advice? This is a proof of concept project I am working on. I would imaging I would be using a NM-xV with a VIC-2FXO or a NM-HDV-xT1.Any help is appreciated.

jaiello2000 · 09-12-2002

You need to do a latency test across the network. Latency can casue echo to be preceptible.Also, the handset volume can also contribute to echo. As folks crank it up, you may experience echo. Try turning down the volume and see if it goes away.Hea...

jaiello2000 · 08-23-2002

Solved My problem....Since I wanted two way calls, I set up both gateways similarly. On each, I created a single DS0-group with timeslots 1-24. This creates a single voice-port 1/0:0. On each gateway, I had a dial-peer for outbound calls. It appe...

jaiello2000 · 08-21-2002

Yes, both are up. The call is initaited between the routers. The "far end" router received the digits, but that is it. I am not sure if the near end needs to indicate it is done dialing or if there is something special needed in the setup of the c...

jaiello2000 · 08-21-2002

I did this and it does the same thing as when calling from a nework phone. I think the problem is that I need to identify one gateway to look like the PSTN and the other to look like cpe. It seems signaling on one end or ther other has to be differe...

jaiello2000 · 07-31-2002

Thanks. I worked out that I have to configure the 2600 trunks and E&M-FGD. Unfortunately, the gateway does not provide dial-tone when configured as E&M-FGD.

Member Since	‎02-13-2002 11:10 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	31

User Statistics

User Activity

Connect two 2600 routers over T1 crossover using E&M trunk? Can't make a ca

I am trying to figure out how to make/ensure there is ANI/Caller ID on outg

Cisco 2600/3600 Connected to a Toshiba DK424

Re: IPT, Half Duplex and slight echo

Re: Connect two 2600 routers over T1 crossover using E&M trunk?

Re: Connect two 2600 routers over T1 crossover using E&M trunk?

Re: Connect two 2600 routers over T1 crossover using E&M trunk?

Re: I am trying to figure out how to make/ensure there is ANI/Ca