Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In CatOS you could enter the command "Show logging buffer 1023" to see an activity log in Catalyst switches running CatOS. Is there an equivaliant command for IOS switches? Thank you.
We have a backbone of three Catalyst 4006 switches, all connected at the Supe II module. The network has no VLAN's other than VLAN1. One switch was replaced with a 4507R and when it was configured the technician put the following trunking statement...
I am installing a 6 port, WS-3206, 1000BaseX Ethernet module insto a Catalyst 4006 switch. The OS and Firmware levels are correct. My question is will I have to reset the switch for it to see this new module. I'm not swapping, but adding a new mod...
My situation is not Hot Swapping, but I'm adding a module that is not in the switch. Do you think a reset is needed to see the module? The previouse post says no. Thanks.
