Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I'm struggling to pass initial configuration for Firepower Service. I get into the wizard as soon as I log into sfr module that asks for IP Address, Subnet, GW, dns etc. After providing all those info it tries to initialize and eventually fails w...
Could someone please provide some information on Cisco Catalyst 9300 Switches (i.e. C9300-24T-E)? Does it support 10G Copper Ethernet Uplinks?
What's the specification of C9300-NM-4M Module? Does it include 2*10G ethernet or it supports optical SFP...
I got to use the public dns servers located outside (8.8.8.8). Got a mail server connected to dmz interface with private ip address (192.168.31.x) statically mapped with a public address (182.150.150.y) along with dns doctoring enabled. Name resulati...
I need to apply a policy nat rule to translate an inside ip address which is under a dmz router connected to the ASA. Is it possible at all?Source IP>Router Interface 1>Router Interface 2>ASA DMZ Interface>ASA Outside Interface>Router>WAN>Destination...
I'm trying to achieve framed-ip-address/static ip address for some remote access vpn clients and ip allocation from pool dynamically for remaining remote access vpn clients. I've configured my asa with the help of http://www.cisco.com/en/US/products/...
I had to involve Cisco TAC as I had some urgency and they concluded that re-imaging of Firepower Module is the only fix and eventually mine was re-imaged with the most recent 6.2.3. It fixed the issue as well.
Hope it helps others who faced similar...
