Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hey all! i am kind of a noobie when it comes to cisco VOIP so please excuse my basic question here.. we have a CUCME 8 setup in our office and i was wondering how can i know what protocal are we using i.e. SCCP or SIP? Another question, we have two I...
Hello William, I executed the show ephone phone-load command and i get "SCCP42.8-3-3SR2S" assoicated with the mac-address of the 7962 phone which i believe is phone's own mac-address.
Hello Rob, I think you seem to have missed the point where i said that i don't have the firmware for 7962 on my flash and hence wanted to know if would ran into any problem for not having the firmware loaded. So far the phone is working perfectly fin...
Rob, it says SCCP so its fine. Btw, what about this part ? "But i don't have the firmware for 7962 in my flash nor do i have the load command in my telephony-service as below are the only two load commands i have in telephony-service:load 7914 S001...
Hello Rob! I followed the troubleshooting the incorrect time stamp and found that i had the wrong timezone set but the correct NTP server. I corrected the time zone and now i am getting the correct time on my 7962 IP Phone. But i don't have the firmw...
