Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I have a requirement to configure a PIX.It is a 515E with 6.3(5) software loaded.We are connecting to a 3rd party via the Firewall.It has 1 inside and 1 outside interface configured.The requirement is that our internal hosts connect to a IP/...
I have a configuration question regarding Bridging in IOS and would welcome feedback on how I can approach this.Scenario:Two Ethernet interfaces on 1 physical router, both in the same bridge group and bridging is enabled.We then have two physical seg...
Sundar / Jon,Once again, a big thank-you for your continued support - it is most appreciated.I am running a 515e but with 6.3(5) software - so your lab is not using the same code.Could there be a difference in NAT Order of Operation between 6.x and 7...
DARN!!static (outside,inside) 192.168.5.20 172.16.5.10 netmask 255.255.255.255 That is how it is configured.Its my mistake whilst I was sanitizing the config.I guess we are out of ideas, the config is correct but I cannot seem to get traffic to work....
Hi Jon/Sundar,Here you go...****************************************: Saved:PIX Version 6.3(5)interface ethernet0 autointerface ethernet1 autointerface ethernet2 auto shutdowninterface ethernet3 auto shutdowninterface ethernet4 auto shutdowninterface...
