Can i have multiple "mapping ID's" (w/ different values) per session?- Can I set the same mapping ID value on more than one session at a time? (so, if there's30 active sessions, can more than one of them have the same mapping ID?)Thanks!!
Known issue: This happens sometimes when you attempt to run the License Update Utility viaa Terminal Services session.Resolution:Run the License Update Utility from the server itself, or via VNC/pcAnywhere
I am not sure about the term hyperthreading but mulitthreading is supported here is a extraction from the ctios admin guide ICM Software CTI Product pdf - Section 3.10 - here is the exerpt:: Service LayerThe Service layer sits between the connection...
Yes in order to perform Load balancing you must use the ICM scripts. Here is a tech tip onhow to configure it in ICM and in the ICM script in orderto load balance with IPIVR. Hope this helps http://www.cisco.com/en/US/partner/products/sw/custcosw/ps1...
You can use the IPCC scripting guide located on CCO http://www.cisco.com/univercd/cc/td/doc/product/icm/icmentpr/icm60doc/coreicm6/config60/ipce60sg.pdf There is also a Tech Tip on troublshooting Translation Routes used with IPIVR. http://www.cisco.c...
