Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Example of the root problem Send a ping (echo request) to outside destination sources from Dialer 0. Echo request goes out Dialer 1 interface sourced with Dialer 0s IP address and gets dropped. If the echo rquest goes out the Dialer 0 interface, ever...
Currently have a 3270 MAR router with a smart serial interface connected to a KIV 7 (military encryption device), then KLAS TA then INMARSAT SDU then goes from aircraft via Sat to land earth station to ground terminal where ISDN replaces INMARSAT equ...
None of this stuff works on my Cisco AP. write erase and erase startup-config are not part of the CLI command available. Also the mode button only got to purple if I hold it down for 20 to 30 secounds. I can do delete nvram:startup-config but it says...
thnks for looking into this. I'm not using nat and to make it clear, my next hop is the same address for both interfaces. If you notice the PBRs and routers refer to a different next hop address. Since both of my interfaces have the same next hop ad...
Taffic has no problem getting to my router via public IP space. Lets say we have Dialer0 = 1.1.1.1 and Dialer 1 = 2.2.2.2. When I send a ping out since both dialer's have the same cost the icmp echos will alternate interfaces. So what you see in wire...
