Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, In my network we are facing high CPU causing because of multicast traffic... The source of mylticast having 155.x.x.x and Group 239.x.x.x.currently we have placed a access-list to stop causing high CPU as below but now concerned is that we are n...
Hi,In our envirnoment we are using LWAP of the mentioned model()but recently we are having issue with some of our APs, they are flapping frequently and when we console in to AP so we got the following error message? Mar 1 00:01:13.794: LWAPP_CLIENT_...
Hi all,I am seeking some of the solution for the e-mail notification on WCS for the Alams, do we have any way by which we receive e-mail notifcation for any alarm only once? currently all the alarms are recuring.... please suggest.Thanks and Regards
I want to bypass all my internal traffic and external traffic from the FWSM for the perticuer subnet. I am having a gateway connected to external network and FWSMcore connected to internal.
Hi Guys,I am also having similar issue but my LOC appliance is not down all the time infact for a short while my WCS sends me e-mail alerts stating that my LOC (IP address) port 8001 is down and after a while come back again and again repeating same ...
HI,May we know where is your source of this multicast stream? also need to know where are your receiver located? To do initial investigation we might need the output of the following command:sh ip pim inter show ip pim neigshow ip mroute* are you abl...
Hi,Thanks for you all for your time and interest in my issue. I would like to share again that as long as there is ACL in our Ds for deny 239.x.x.x it is not going to cause CPU high but at the movement we are taking it off CPU rising very fast.My con...
