Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had strange performance problems between Clients and Servers. After sniffer the traffic I found that the order of the IP-packets had changed after passing an etherchannel. The loadbalancing algorithm is set to src-dest-ip. So how could the order o...
So I guess there are no error messages left. Now you have to enable multicast step by step on the vlan's, until the error messages apperars again. I guess there is a nasty client or something else connected to a vlan, which cause a lot of multicast e...
Hi,We are using the Sup720-3B with around 200 Vlan configured for multicast. We have a MET table usage of 2%, so I expect for you a usage of less than 20%. I would enable multicast vlan by vlan and check when the MET increase unexpected. Than you cou...
Hi Kevin,The load balance algorithm is the same on both side. Doe not use rspan on a Sup720 with any SXD- release, if you are not connected to the console-port. The CPU-load rise from 7 to 99% within a second. Should be fixed with the SXE release. Bu...
