Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 x SDSL lines (from the same ISP) and 2 x 2800 routers- these terminate with Site2Site vpn tunnels to an ASA.Does anybody know how best to configure these to utilise both lines at the same time and maybe have some resilience as well.many than...
Hi ...I have a problem which I just cannot work out, I have 2 x 6509's with GBIC modules in - they are currently running CATOS.I have successfully (and easily !) setup trunk links between them and numerous 3500 switches (also with GBICs). The trouble...
I know I should have remembered but I didnt....I have been using the 90 day trial ACS which expired before I bought a copy.Have I lost everything and how to I go about licencing the product now that I have bought it?thanksAndrew
HII have two 2800's each with its own SDSL line, with tunnels terminating at two VPN 3030 concentrators - one in London and one in NY. How can I multilink/aggregate these lines?thanksAndrew
Hi ...I am trying to find out if anyone knows the answer to the following.I have two 2800's each connected to separate SDSL lines tunnelling through to a 3030 concentrator. I would like both routers to load balance/load share and be on the same netwo...
Hi ..thanks to all those who have replied, unfortunately still no luck.I have changed both ends from on/desireable/auto step by step and now have enclosed my current config (I have just changed the patch leads again for good measure!).Thanks for the ...
Hi Massimiliano,yes both ends are set for dot1q - as soon as I replace the 3560g and put in an old 3550xl it works fine...very strangemany thanksAndrew
hi there.sorry maybe I didnt explain very well but I have 2 x 2800's going into 1 x 3030 it is the 2 x 2800's which I need to load share or load balance not the 3030.Still hope you can help.many thanksAndrew
