About sheeraz.hussain

sheeraz.hussain · 05-13-2020

I have connected 2 x Nexus 9000 back to back using Mgmt port but see below when i did show cap neigh SW1(config)# sh cdp neCapability Codes: R - Router, T - Trans-Bridge, B - Source-Route-BridgeS - Switch, H - Host, I - IGMP, r - Repeater,V - VoIP-Ph...

sheeraz.hussain · 05-14-2020

W1(config-if)# sh cdp neswitch(9YV6VWB5Q5E)Eth1/2 127 R S s N9K-9000v mgmt0 I will reserve another slot soon and capture the show version information. FYII don't have that issue when using Eve-ng.

sheeraz.hussain · 05-13-2020

Just to verify, i have shutdown E1/2 and the neighbor is gone, but as soon as i no shut E1/2 the CDP neighbor is back... some is not right and developers need to take a look.SW1(config-if)# sh cdp neDevice-ID Local Intrfce Hldtme Capability Platform ...

sheeraz.hussain · 05-13-2020

I did verify and that's the only connection i have... so no chance to misread that :)

sheeraz.hussain · 09-18-2014

You need to configure MTP because H.323 does not support Hold/Transfer and that's where you need MTP resources to support.

Member Since	‎09-24-2009 01:31 PM
Date Last Visited	‎05-17-2020 01:01 PM
Posts	5

User Statistics

User Activity

Nexus Mgmt port connectivity

Re: Nexus Mgmt port connectivity

Re: Nexus Mgmt port connectivity

Re: Nexus Mgmt port connectivity

You need to configure MTP