Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to connect a paging system to Cisco Call Manager 6.1. I have a router 2811 with FXS and FXO ports. The manufacturer of the paging system told me that his system acts like a telephone system, so it should be connected to FXO. The availabl...
Hello,we would like to connect an old paging system to our CCM 6.1 system. So we have a FXO port on a 2811 router connected to this paging system. The paging system is currently configured with something called "power provided externally" (translated...
The ATA-186 (SCCP software) shows an annoying behaviour, when the remote phone is hung up: it produces some sort of a busy tone. But every eight pulse is longer than the others and the pause between the beeps is too short. In addition after a few sec...
Pix 515 V7.0.2: Road-warriors create VPN connections through the "outside" interface. Now I would like to have ALL traffic arriving via the tunnel directed to the inside interface. As "road-warrior" as no fixed IP address I have a default route to th...
This problem is obviously not one of the Call Manager but one of the ATA firmware. Unless Cisco decicdes to fix the firmware of the ATA there is no way to solve the problem.
I tested it here, too. Calling a remote phone on-hook resutls in a proper busy tone. Only the tone you get when the remote phone goes off-hook during a call from the ATA results in this strange tone. But this is the normal situation with a door inter...
The door intercom is one from Behnke (www.behnke-online.de). A lot of trouble disappeared when we connected the door intercom to its own power supply. Before it used the line power from the ATA.The problem with the tone is independent from the door i...
Yes, both files are installed. The only difference after the installation of these files was, that the speech part after a bunch of busy tones doesn't appear anymore. But the busy tone is still wrong: every eightth beep is longer than the previous se...
I was unable to solve the problem. What I realized is: this happens only if you set the device to a German locale. If it is set up as an US device there is no such problem. But then the tones are completely wrong. Thus, I have to use the German local...
