Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, The topology is in the attached file. My problem is I can't ping client 2 from client 1 and Client 1 from client 2. Interface 2 and 3 have same security level. Here is the configuration of the ASA :!ASA Version 9.8(1)!hostname PTF-FW002domain-...
Dear all,Here is my problem :I have the network A with a DHCP Server.Network A knows the network B only with its NATed addressesIn DHCP Server (which is on a Solaris machine) the remote client is configured with NATed informations.In network B I have...
Dear all,I need your point of view on a customer request.I have aclient connected to f0/1 of a router which sends UDP packets to a server connected on the F0/0 of the same router..My customer would like to have these UDP packets on 2 servers. One loc...
Dear all,I have a problem on my catalyst 6509 on which I would like to do the following things :I have some Vlans in which multicast is enabled.In tose Vlan theres is a router which is default router for equipements.I had enabled multicast routing be...
En cours de modérationDear all,I write on this community support to ask you your help to made a special configuration.I have a network of 3 cisco 2611XM routeurs connected on the same network with their interfaces f0/0.On the f0/1 of the 3 routers I ...
Hello, Thanks for your answer but problem cames from my NAT rules. I have configured a previous NAT on other interface and this is this NAT rules wich is used. Problem solved by erasing all my NAT rules and redo a NAT on the correct interface. Regard...
Thanks Peter for this answer,I think I will configure a DHCP server on a router but it remains a question, can I add some options on my clients from the DHCP master server.Br,Jean-Yves
Thanks jon for your answer, this is what I think, I will suggest to make a GRE tunnel to the second server to allow multicast without routing it on all routers.Br,Jean-Yves
OK,When you go in advanced VPN Parameters then in IKE policies, select both for direction/Type, Agressive in exchange mode if you are using IP address for identifiers, enable dead peer detection, set the detection period to 30 sec for example and se...
