Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an IPSec tunnel configured on my Cisco 1941. The other device is an ZyXEL router.I can see the tunnel is up but there is no traffic.This comes out the show crypto ipsec sainterface: Dialer1 Crypto map tag: CMAP_AVW, local addr 10.10.10.89 ...
I have some questions about how to configure my Cisco 1941 with a routed subnet from my ISP to forward them to 1 or more servers in my LAN.The situation is:1 Cisco 1941 (with the default 2 Gigabit ethernet ports)So I can use 1 for the connection to m...
Hi ttemirgaliyev,Yes, your right. This is traffic. I found out what is the problem.I can ping all network devices in the 192.168.200.0 subnet, except the 2 servers 192.168.200.2 and 192.168.200.242These 2 servers connect to the internet through 2 oth...
Hi John,We are almost there!I added permit icmp any any echo-reply, and now I get this result:Traceren van de route naar www-nu-nl.gl.sanomaservices.nl [62.69.166.18]via maximaal 30 hops: 1 <1 ms <1 ms <1 ms 192.168.1.15 2 * * ...
Hi John,Thank you for your reply.The good news is that the access-list 110 works fine now. Thanks about that!The other news is that I have internet traffic with the access-list 190 on the dialer1. But strange is that a traceroute to a host on the int...
Hi John,Yes, your right, I want to block traffic coming from vlan 192.168.1.0 to vlan 192.168.1.0. That's were access-list 110 is for.Thank you for your last post. I am almost there now.Incoming traffic is restricted to only port 443But now, de serve...
