Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our company presently has a symantec firewall. It is planning to introduce an additional Linux firewall. The two fierewalls should work in load balancing fashion. The company would like to introduce a PIX device that would be external to the two fire...
I have configured a DDR with dialer profiles on cisco 3640 and 803 routers. Unfortunately I am unable to bring it to function. I have attached output from debug commands. Any suggestions to the problem are appreciated.Thanks,HOMCIS03#ping 192.168.104...
I am very fresh in this area. Now faced the first challenge! I have users who use asynchronous dial-up connections. Recently some have been complaining that the connections are being terminated with in very few minutes. The error message that I obse...
We have a 6509 switch that is basically used to connect Windows NT and 2000 servers on GBIC ports. Recently some of the servers started to loss link abruptly and gain again. The correct error description on the telnet session is as follows "Port x/y...
I have attached the requested config with so´me modification.HOMCIS03>enPassword:HOMCIS03#sh runBuilding configuration...Current configuration : 38532 bytes!! Last configuration change at 10:53:21 MESZ Fri Apr 26 2002! NVRAM config last updated at 10...
There is no speed or duplex mismatch. Both sides are are configured for full duplex 1000. The show counter values are generally with in normal limit. One importnat info: When I connect the affected sever to another switch (4006) it will function with...
