Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys, quick question, how can I find Cisco ACS serial number on my existing ACS (application)? Customer asked me because the product should be updated but I don't know where to find this information and I also don't know where I put the paperwork ...
Hi,I'm troubleshooting a connection problem between a client (inside) and a server (outside). The client (139.96.216.21) starting the TCP session to the destination (121.42.244.12). Please have a look at attachement... What does the TCP FINs mean a...
Hi, I have some new 2960-8TC-L and I would like to upgrade them with the following firmware: c2960-lanbasek9-tar.122-25.SEE3.tar but it's not possible because the Min.Flash which is needed has to be 32MB and this is what I have : switch#dir flash:Di...
Hi Jorge, this happens only to this client which is within the subnet 139.96.216.0/24 and also located inside the firewall. Other clients, which are located in other countries but with them same setup (Firewall in front of the WAN connection), doesn'...
'Fat Fingers'!!! Yes, you are right, I double checked all kinds of available releases for the 2960-8TC and the one which I would like to use (c2960-lanbasek9-tar.122-25.SEE3.tar) isn't listed ... hmmm, but when I'm using the IOS upgrade planner ...
archive dowload-sw/overwrite tftp://ip.ip.ip.ip/c2960-lanbasek9-tar.122-25.SEE3.tarthe error message is:Error: The image in the archive which would be used to upgradeError: system number 1 does not support that particular system.
hmmm, yes you are right, but my customer would like to use the archive-download procedure by using the .tar file and what I also found at the ios upgrade planner is the declaration: The selections you have made are: Platform: CAT2960 Release: 1...
