Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I've this problem. I've put an image with an extract of my network topology.In Milan w've two main network connected directly by a 2821 router (192.168.2.0/23 and 192.168.4.0/23), then a network that I use as dmz (192.168.40.0). On the other si...
Hello all,I've a problem that is making me crazy.. I've configured a lot of PIX and ASA v. 7, now I'm configuring for the first time an ASA with sw 8.2.The config that I want to make is very simple: dynamic NAT for the inside client and some static f...
Hello,I've a stack with 3 Catalyst WS-C3750G-24TS-S1U with IP Base software image.Now I need to use PBR and so I need to upgrade to IP Service image.I need to buy an upgrade for each member of the stack? Or I can buy just an upgrade for all the stac...
I've sent you a private message with the complete configuration.This is the routing table of my router:D 192.168.30.0/24 [90/3072] via 192.168.2.243, 1d07h, GigabitEthernet0/0.2D EX 192.168.210.0/24 [170/28416] via 192.168.2.201, 1d07h, ...
Ok ... Soon I do a crash test of two ASA5510 throwing them out the window ...I'm still trying to solve my problem without results.It seem to be a NAT problem but I've double checked the NAT exception and they're right.If I do a packet tracer form Mil...
Hi Diego,thanks for your help.I've tried to make the config change that you've suggested but I have the same issue.The very strange thing is that I can ping 192.168.210.0 hosts but not .200. that are managed by the same crypto map...do you have any o...
On the firewall the mask is the same as in the switch.Firewall:interface Ethernet0/0 nameif inside security-level 100 ip address 192.168.2.201 255.255.254.0 standby 192.168.2.202 rip authentication mode md5 rip authentication key ***** key_id 1!route...
