Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We've configured Phone VPN and tested to ensure everything was setup properly and it is.But once we setup the user's phone (which we've also tested) when they attempt to connect the phones at home through residential routers (linksys and i believe...
Hi all,I was wondering if anyone has ever come across this problem before.We have a cluster of 2 CUCM version 8.5.1.11900-21, they are both located at different location connected via a WAN link.The connectivity between the CUCM is fine so is the DBr...
Found the answer to my question in the following posthttps://supportforums.cisco.com/thread/2206564Seems the way to go for now is to configure the tftp manually. Less troublesome than configuring the ip address all together.Jonathan S
Hi jillesmiedema,If you connect to the switch and use a packet sniffer such as wireshark you should be able to determine the ip address by reading the info in the CDP packets (given that CDP hasn't been disabled). HTH
Hi dlaminw1,Did you configure the cluster in your publisher first, in order for the publisher to accept a subscribe request it must first be aware that it will be in the cluster.http://www.cisco.com/en/US/docs/voice_ip_comm/connection/8x/installation...
Ok at this point let's make sure it's not a L1 or L2 problem.Do a show int gi0/2 on both switch to make sure they are both in an up/up state.Jonathan S
Hi jszapipes,The terminal monitor error received when he plugged in the device confirms it's port-security putting the port in err-disablepsecure-violation error detected on Fa0/2, putting Fa0/2 in err-disable stateOtherwise the message would've said...
