Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have set up a wireless bridge configuration using 1230 APs (one root, the other non-root bridge). I am using yagis. Is there a tool to align the antennas i.e. in the CLI ?
Does any one have experience with LWAPP over a NAT device. Trying to implement multiple AP behind a NAT device. Cisco says only full cone (1-1) works. I have it working with 1 (public) to many (private). Input appreciated.Thanks,Chris.
I am using 13 WLC4404-100 switches (version 3.1.105.0)., with about 200 1010 APs. We are regularily getting messages in the eventlog like :AP 'ap:25:1d:e0', interface '802.11b/g' is down on Controller ''. After 1 minute: AP 'ap:25:1d:e0', interface '...
Is it possible to upgrade the Aironet 1200 series APs to the LWAPP firmware (c1200-rcvk9w8-tar.123-7.JX), WITHOUT a WLAN controller connected ? I have tried this and the hash key is not generated in the AP config file, this file is needed to add the ...
Facing the same issue here. Control Path up, Datapath down when Checkpoint firewall policy is pushed with SecureXL enabled.What kind of firewalls are in between achor and foreign controller ?
What version of firmware is in the AP. If you cannot go into config mode, it smells like you have an AP with LWAPP and there is no way to configure a static IP address. Convert to autonomous.
