Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a simple PIX network setup, basically just allowing Internet Access and some limited VPN stuff. There is only one computer on the inside that cannot see outside, and that is the domain PDC which is also running DNS and WINS. I think my problems ...
I am attempting to do a port redirection on the outside interface of the Pix with the new commands that v6.0+ provides.Any tcp traffic on port 3000 that comes to my outside interface is statically translated with the static(inside,outside)command an...
Is there a way to disable the CSU/DSU functions of the WIC-1DSU-T1's? I have a router currently terminating 2 PRI's with the WIC card. Eventually, I am going to have to move both PRI's to an Adtran Atlas, and pass the PRI's back thru to the router. ...
How do you get the first line in an auto attendant hunt group to roll to the next number? I've got a pilot point set, it rings in to the first hunt group member and then goes strait to his voicemail every time. It never rings member #2's extension. ...
I am installing a PIX for a customer who already has a VPN setup in place. He's got a WIN2K server at his main site, and is building L2TP tunnels over the internet from several remotes. I need to put the PIX between the current VPN server and the rem...
Thanks for the reply Scott. Here's the part of the config in question, with some of the addresses changed to protect the innocent. As you can see, the PIX is getting it's outside address from DHCP (cable modem)but it hasn't changed in years, so I gue...
No, they can, but the hunt groups follow the forwarding paths as set on the phones. If a phone in a hunt group forwards ring-no-answer to voice mail, then that's where the calls will go. My misunderstanding was that I thought the Call Manager perfor...
I was experiencing same problems with similar equipment. I was unable to totally eliminate the echo in calls to the PSTN. If you read cisco's echo troubleshooting docs, most echo is created in the network in equipment you have no control over. If ...
Try applying the 7-digit dialing route filter to the 9.@ route pattern. This will let the digits outpulse without waiting for a local area code. If the 7-digit route filter is not included in your version of CM, you can build it. Just create a new ro...
