Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a question, I would like to migrate from ACS 5.5.0.46.1 to ACS 5.7 however Cisco says to install the mandatory patches but they don't stipulate what exactly is the mandatory patches ?The ACS is installed in a virtual enviroment.A clean inst...
Hi, I'd like to deploy OAM but I can't seem to get my head around the deployment method. I have a fiber ring running QinQ:ME3400G-12CS-A as the distribution nodes ME3600X-24FS-M as the coreCan someone provide me with assistance with a possible diagra...
Hi,The native vlan is only for untagged packets, so any packets incoming that has no tag attached to it on a layer 2 basis will be caught by the native vlan tag, in your scenario, if the layer 2 VLAN 10 is defined on both ends and allowed across the ...
Thanks again for your reply. So basically what I'm trying to achieve is QinQ tunnel to act as a last mile carrier grade network so that the SP can tunnel through my network to their client which sits at the end.
ME3600X facing toward the SP which we ...
Thanks for your response, much appreciated. What if I were to only match the outer tag ? because the inner tag would be the same for every client so I'd only match the outer tag and pop it however client 1 and 2 should never see each other while main...
Thanks again for your reply! So if I were to disable split horizon only on the sub interface ? that would allow it act like ME3600X a service instance under the sub-interface ?
Hi Xander,
Great article, very insightful! I'd like to ask you a question regarding the above, I currently have MSTP running in an IOS like enviroment with 2 ME3600X's(QinQ) as the root bridge and backup root bridge which I'm looking to move away fro...
