Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm actually wondering of the best practice about the FC domain ID.when configuring a new switch member of a fabric with multiple vsans, is it better to set the fcid as static or prefered? if you go for a prefered settings, is it a good Idea to se...
Hello,I'm facing a behavior that is absoluty insane.quick intro:a core edge topology with 2 edge switches, 1 MDS 9134 and 1 Nexus 5548 connected (ISL) to a director MDS 9509. they are all running NXOS 5.xhosts are connected to the 2 switches and the ...
Hello,I have a Nex 5548 version 5.0(3)N1(1b)at this time release to configure FCoE was simply the steps of mapping VLAN to VANS, creating vfc and adding the vfc to the good vsan..now I'm stuck.I've my interface Eth in a PO. I bound the vfc to this po...
Hello,I'm wondering if there are ways to automate the backup of the zones and zoneset that you can perform with the fabric manager GUI?maybe through the CLI?many thanksEric
Hello,I have several Clariion connected to a MDS 9509 running SANOS 3.3.1c.From Fabric Manager I ran the end to end connectivity tool against a zone-set.After the tool ran, I received several warning from my Clariion regarding initiators logged in bu...
Sorry for my late reply. I was off sick.I will take into consideration every facts you just highlighted.I might go for a complete rebuild of the fabrics. I will try it out on a test environement first.thank you again EricSent from Cisco Technical Sup...
Hi Steven,thank you for your answer. Your ID's numbering sounds good.static is more or less the where I thought I would go for. the only point that I don't know is changing the FCID of an existing switch.I guess that once the ID is changed to a prop...
I do absolutely agree with you but it does.when the switch21 goes down, the connectivity between the switch11 and switch01 is cut.I will go ahead and open a SR because I'm loosing my mind with this one.Eric
Sorry about the delay.this was related to the fact the Cisco doesn't enable by default the QOS for FCoE on their nes Nexus 55xx switches.enabling the proper QOS for FCoE can be found on the following page:http://www.cisco.com/en/US/docs/switches/data...
