We're running a UC540 at a customer, who's got 4 lines for incoming/outgoing calls. Out of their 6 employees, only 2 should pick up calls and hand them over to the others.Now my question:Is it possible to configure the UC to send out a busy tone to t...
I got a UC540, using BRI 0/1/0 for my German ISDN. Everytime, I do 2 outgoing calls, the BRI-Port goes up/down. During this time I'm not able to make a call for about 15 seconds, until the Port is up again.Any ideas?
Some hint that might help (didn't help me tho):CLi shows this, everytime my described problem occurs:%MARS_NETCLK-3-HOLDOVER-TRANS: Holdover timer exceeded for Controller BRI0/1/0Any suggestions how to fix this?