Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a route in my BGP table that's being suppressed that I can't seem to un-suppress. I believe I'm missing something simple but I can't seem to put my finger on it. I have an aggregate for 10.0.0.0 255.0.0.0 but I'm trying to un-suppress the 10.1...
I have a network design with 2 Nexus 9K's as the core swithces and an upstream ASA active/standby pair. The ports connecting the Cisco ASA to the Nexus are access ports and those SVI's live on the Nexus. The Nexus's are connected with the peer link a...
I'm designing a classic 3 tiered network with a pair of Nexus's serving as the core and a pair of Nexus's serving as the distribution layer. I was wondering how I can incorporate VPC's between the core and distribution while still using layer 3 links...
I have several point to point links running LDP and OSPF. I was curious what would be a recommended mpls ldp igp sync holddown timer to configure on these links. I know its a best practice to have on there in case there's a convergence issue. What's ...
I have a simple scenario where I'm doing IP SLA for failover. See attached diagram
I have an MPLS and internet circuit. All internal traffic goes over the MPLS and the default route goes over the internet. In the event the internet traffic fails I w...
I actually do have a permit statement at the end.
"route-map ALLOW_CRO permit 30"
I don't want to modify the BGP config that's already there. I just want to modify the prefix-list and route-map statement. I'll try adding a permit statement before t...
