We have the following system \ environment, two redundantly connected Cisco 6120XP interconectorer linked to three Cisco UCS 5108x chassis with 13st cisco blade servers configured. As information, I can say that we have NetApp FAS3240 storage and no Nexsus switches. We have vmware virtualization platform. This is what happened. We'd upgrade UCS Manager from version 1.4 directly to 2.03 (c). At the time we had done a failover from the primary to the secondary interconector. We ran at that this time all network traffic through one I / O module on each chassis. When we pressed the upgrade on the primary interconecter so suddenly chassis number two reboot and we lose about 40 servers. VMWare has taken them down neatly but we lost it unfortunately. Now the question is why did this happen? Rgds Tobias ... View more

Hi I have 12 UCS Cisco blade server, how should I think. Should I buy more servers or more memory. I have 96Gb in every blad to day. I run VmWare ESXi 4.1 Rgds Tobias ... View more

HI I have added a new vLan nic and added it to the blade server but I don´t get any connection to the network. Do I have to initate it in the fabric switch or any where else? Iám rather new to the Cisco UCS environment so basic how do I do to add a nic? //T ... View more

Hi We have three Cisco UCS 5108 blade server chassie with 12 blade servers (B200 M2) which we have installed VmWare Esxi 4.1 on. We have done a server template with all vLan, but now we want to add 2-3vLan how can we do to automate this? Regards Tobias ... View more