Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have installed an NM-2CE1T1-PRI module in a Cisco 2811 router and issued the "card type T1 1" command as well as the "controller t1 1/0" and "controller t1 1/1" commands and sub-commands as required, however, the associated serial interfaces never ...
I need to establish RAS access to my network via an ISDN PRI line. Most users will be single POTS line users but I'll also need to allow bundled POTS line users via Microsoft multilink PPP. I'm planning to order a Cisco 2811 to handle this using a ...
We are looking to replace 3 separate Internet T1s from various providers with a single provider's T3. T3 would employ all remote site IPSec VPNs, Cisco client VPNs, as well as general internet access. What Cisco router, modules, specs would be reco...
Thanks for your response. I have since determined that this was exactly what I needed and have oredered and rece'd all but the PVDMs. Apparently, finding light in a black hole might be easier than obtaining one of this modules. Thanks again.
Thanks GP ! I have looked at the module as well. I was more looking for suggestions/recommendations on a specific router. I am trying to determine which router could best handle my requirements (without price overkill) - I'm currently investigatin...
Be careful with your ACL syntax and order. As listed all traffic will satisfy the first ACL line and pass (ip any any). Your second line has an erroneous "any". Your "deny" lines will only negate "tcp" traffic where your "permits" are allowing all...
